You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
My Radiomaster Pocket is running the "RM Factory" version (POCKET-V2.9.0-PROD-2023.7.27-C.bin?) of EdgeTX, with ELRS. I haven't tried updating to EdgeTX 2.10 because I've seen #235.
The Tx is receiving telemetry from Ardupilot and I have it set up to give an audible Rx battery low voltage warning.
I've just installed the Yaapu script and it displays but shows "no telemetry". I am unable to enter the Yaapu configuration menu with TELE -> RTN -> TELE. I can bring up the Yaapu debug screens.
How do I access the configuration menu?
The text was updated successfully, but these errors were encountered:
I was unaware that CRSF passthrough needed to be enabled on the flight controller for Yaapu telemetry (if this is explicit in the Yaapu docs, I didn't see it).
This thread/post gave me the information I needed to configure arducopter and enable Yaapu telemetry. Telemetry updates were slow initially, much improved by changing the telemetry ratio.
My Radiomaster Pocket is running the "RM Factory" version (
POCKET-V2.9.0-PROD-2023.7.27-C.bin
?) of EdgeTX, with ELRS. I haven't tried updating to EdgeTX 2.10 because I've seen #235.The Tx is receiving telemetry from Ardupilot and I have it set up to give an audible Rx battery low voltage warning.
I've just installed the Yaapu script and it displays but shows "no telemetry". I am unable to enter the Yaapu configuration menu with TELE -> RTN -> TELE. I can bring up the Yaapu debug screens.
How do I access the configuration menu?
The text was updated successfully, but these errors were encountered: