current sensor orientation

[legend069]

hi, almost finished this neat project, just need to solder on the current sensors.
it's hard to tell by looking at the photos what orientation i need to solder the current sensors.
can you please assist.

thanks.

[globalcitizen]

According to current kicad sources, pin 1 should be to top right in both cases. This is indicated by the silkscreen circle on the current revision of the PCB in the kicad sources. Unsure if that's the same version you used.

If unsure, double-check the opposite pin (pin 5 = other side of IC and other end of IC) should have a via to GND.

[zapta]

Yes, both dots are upper right in that orientation. https://i.imgur.com/kfjeOYc.png

…

On Fri, Apr 22, 2022 at 6:15 PM Walter Stanish ***@***.***> wrote: [image: Screen Shot 2022-04-23 at 09 13 28] <https://user-images.githubusercontent.com/505366/164847530-f137a2fe-5d19-4e91-9425-296f2816fdc5.png> According to current kicad sources, pin 1 should be to top right in both cases. This is indicated by the silkscreen circle on the current revision of the PCB in the kicad sources. Unsure if that's the same version you used. If unsure, double-check the opposite pin (pin 5 = other side of IC and other end of IC) should have a via to GND. — Reply to this email directly, view it on GitHub <#9 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AAQVMQMCOUZBNIAPRJYRCO3VGNFL3ANCNFSM5IGDDV7A> . You are receiving this because you are subscribed to this thread.Message ID: ***@***.***>