We read every piece of feedback, and take your input very seriously.
To see all available qualifiers, see our documentation.
You can continue the conversation there. Go to discussion →
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Describe the bug the samples/helloworld Demo can run and print well on BOARD_NRF52840DK_NRF52840.
but this hex file cannot boot up on my board.
for simplest case, my custom board only use 4 pins (SWC SWD GND VCC) from E73
someone suggests set BOARD_ENABLE_DCDC=n but not work for me.
so i need some help thx
The text was updated successfully, but these errors were encountered:
Can you get console output?
Sorry, something went wrong.
no output and other information.
today I try to link the PIN to the LED but it not lighted.
I guess the board even not boot..
Probably because you haven't connected a 32KHz crystal. This isn't a zephyr problem.
E73 has crystal. And I can run other firmware(not zephyr based) on my board.
No branches or pull requests
Describe the bug
the samples/helloworld Demo can run and print well on BOARD_NRF52840DK_NRF52840.
but this hex file cannot boot up on my board.
for simplest case, my custom board only use 4 pins (SWC SWD GND VCC) from E73
someone suggests set BOARD_ENABLE_DCDC=n but not work for me.
so i need some help
thx
The text was updated successfully, but these errors were encountered: