This project simulates the embedded controller in a microwave oven
The project is implemented using Tiva TM4C123GH6PM microcontroller depending on the state machine diagram attached on the github repository At the beginning, you need to enter a choice on the keypad to begin:
-
If A is pushed on the keypad (for popcorn), the LCD should show “Popcorn” and then cook for 1 minute while the remaining cook time counts down (in seconds) on the LCD, then clear the LCD after cooking completes.
-
If B (for Beef) or C (for chicken) is pushed on the keypad, the words “Beef weight?” or “Chicken weight?” (respectively) should appear on the LCD. After that, the user must enter an integer value between 1 and 9 on the keypad to indicate how many kilos are there to be defrosted,After a valid number is entered the LCD display is cleared and show the value of the weight on the LCD for 2 seconds then start cooking while the remaining cook time counts down (in seconds) on the LCD o Beef is defrosted at a rate of 0.5 minutes per kilo. o Chicken is defrosted at a rate of 0.2 minutes per kilo. o If an illegal number is entered, then the LCD should show “Err” for 2 seconds, then show previous message to set kilo again
-
If D is pushed on the keypad, the words “Cooking Time?” should appear on the LCD. After that the user can enter a value between 1 sec. and 30 min. to indicate the cooking time required in minutes and seconds. This value is displayed on the LCD as it is entered, right to left. For example, pressing 1 displays 00:01, then pressing 2 displays 00:12, then pressing 4 displays 01:24, then pressing 5 displays 12:45. Press push button SW1 to clear the LCD display and show 00:00 and press SW2 to start cooking (if valid time) and counting down
But, if the time entered is invalid, display "invalid time" on LCD for 2 sec then enter time again
-
Switch SW3 (external push button), position 1, will simulate the microwave oven door latch, where the switch being down would be simulating the open-door situation and the switch being up would be simulating the door closed situation. Only when the latch is closed should the oven be able to be started. o When SW2 is pressed, the oven starts operation. o When SW1 (external push button) is pressed for first time, the oven operation pauses (keeping remaining time on the display). o When SW1 is pushed for second time after pressing it for first time, the time is cleared and the cooking stops. o If SW2 is pushed after the oven is paused and the door is closed, then cooking must resume from the time it was paused. • If it is cooking, opening the door should pause the cooking and keep the remaining time on display. • When the microwave is running, the array of LEDs should be on. When it is stopped, they should go off. If paused, the array of LEDs should blink till the cooking is resumed or stopped. When the microwave completes its function and timer has counted down to zero (regular timed cooking or defrosting), the array of LEDs should flash 3 times and the buzzer should produce an audible tone/alarm during these 3 seconds
To run this project, you need to intsall keil version 4 -embedded system platform-
To see live demo for project, follow this link:
Zeyad Mohamed zeyadmohamedasu@gmail.com
Bishoy Yousry 1900733@eng.asu.edu.eg
Hassan Khaled Hassankhaled006@gmail.com
Yusuf Ebrahim yabrahim500@gmail.com
Andrw Adel andrewadel3322@gmail.com
Basel Khaled zoulsmsm@gmail.com
© Embedded Software Team ,Faculty Of Engineering Ain Shams University Cairo
Licensed under the MIT License