Skip to content

Linux install

Florian Didron edited this page May 20, 2019 · 3 revisions

In order to use Wally and flash your board on Linux, you need to:

  1. Install the required dependencies.
  2. Add a udev rule file to your distro.
  3. Download the Wally binary.

1. Install the required dependencies.

Note some distributions might already have these dependencies installed (ex: Ubuntu)

Wally requires three dependencies to run properly: gtk3, webkit2gtk and libusb.

1.1 Arch and its derivatives (Manjaro, Antergox, ...)

sudo pacman -S gtk3 webkit2gtk libusb

1.2 Debian and its derivatives (Ubuntu, Kali, ...)

sudo apt-get install gtk+3.0 webkit2gtk-4.0 libusb-dev

1.3 Red Hat / Fedora and its derivatives (Centos, Scientific Linux, ...)

sudo yum install gtk3 webkit2gtk3 libusb

Note: Feel free to open a PR with an update to the docs if you would like your distro listed above.

2. Create a udev rule file

While low-level device communication is handled by the kernel, device-related events are managed in userspace by udevd. Custom .rules files can be defined in order to get access to those events without elevated privileges.

In /etc/udev/rules.d/ create a file named 50-wally.rules:

sudo touch /etc/udev/rules.d/50-wally.rules

And paste the following configuration inside:

# Teensy rules for the Ergodox EZ Original / Shine / Glow
ATTRS{idVendor}=="16c0", ATTRS{idProduct}=="04[789B]?", ENV{ID_MM_DEVICE_IGNORE}="1"
ATTRS{idVendor}=="16c0", ATTRS{idProduct}=="04[789A]?", ENV{MTP_NO_PROBE}="1"
SUBSYSTEMS=="usb", ATTRS{idVendor}=="16c0", ATTRS{idProduct}=="04[789ABCD]?", MODE:="0666"
KERNEL=="ttyACM*", ATTRS{idVendor}=="16c0", ATTRS{idProduct}=="04[789B]?", MODE:="0666"

# STM32 rules for the Planck EZ Standard / Glow
SUBSYSTEMS=="usb", ATTRS{idVendor}=="0483", ATTRS{idProduct}=="df11", \
    MODE:="0666", \
    SYMLINK+="stm32_dfu"

Note: The snippet above defines rules for both the Ergodox EZ and the Planck EZ. Feel free to only copy the block relevant to you.

3. Download the Wally binary and run it

Download the latest "Linux 64" version from the release page, make it executable (chmod +x wally) and execute it.

Ran into an issue while following this guide? Feel free to contact us and we'll help!

Clone this wiki locally
You can’t perform that action at this time.