agio
lansalot edited this page Jan 25, 2024
·
1 revision
AgIO is the program that runs on your tablet and acts as the communication layer between AgOpenGPS and whatever steering board you have built.
Whether using USB, or ethernet, its role is the same - to take messages from hardware to software. Without AgIO running, AgOpenGPS will be running blind and won't know where it is, or how to steer the machine. You can start it and minimise it.
Check out the AGIO orientation guide, here.
- All-In-One Board versions and how to order
- Assembling the board
- Other pieces to be able to assemble
- Ampseal 23 pinout
- Ampseal-Wiring-Harness example
- Machine Board for relay control
- Machine board - full guide
- Rate Controller for variable rate and section
- GNSS / GPS - ZED-F9P
- GNSS Antenna
- Teensy 4.1 a.k.a the brain of the board
- IMU for roll compensation
- Wheel Angle Sensor
- Windows Tablet
- Cytron MD13S driver
- Steering with Motor
- Steering with Baraki hydraulic block
- Steering via CAN bus
- Steering via Danfoss
- Steering with Keya CANBUS wheel
- Connectors
- Miscellaneous hardware