You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Hey, how is the usability as replacement of the original BTT firmware? Do all features (movement, CAN-bus) work? Why is there no current development going on?
I would love to update my BTT Servo42B, as it lacks so many things...
Should i give this a try?
The text was updated successfully, but these errors were encountered:
Hello,
Unfortunately, there is an unsolved issue with step counting that makes the project unusable. No matter what I tried, I was unable to produce accurate step counts over full prints. I’m not sure how BTT did it, although a firmware binary is included in the GitHub if you’d like to try reverse engineering it. As a result of this issue, I stopped working on the project. Features such as CAN bus support are possible… likely with an adaptation to the Klipper firmware. I remember looking into it, but had already switched my printer over to TMC2130s. These days, I moved to a X1C… once you go Bambu you can’t go back. Best of luck to you… sorry that I can’t deliver better news.
Best,
Christian
Hey, how is the usability as replacement of the original BTT firmware? Do all features (movement, CAN-bus) work? Why is there no current development going on?
I would love to update my BTT Servo42B, as it lacks so many things...
Should i give this a try?
The text was updated successfully, but these errors were encountered: