Skip to content

CyberXZT/atx-q630

Repository files navigation

ATX - Quadra 630 PSU Conversion Kit

PCB Screenshot

This is an ATX/Quadra 630 PSU conversion PCB that I designed a while ago and never got around to uploading.

BOM

I am not an electrical engineer. I take no responsibility for any damage these designs may cause. Use these designs with extreme caution.

Quick Notes

  • R2 is unused.
  • U1, C1, and C2 provide the -12V rail. If your PSU provides -12V, do not populate these. Instead, bridge the "ATX -12V" jumper.
  • 3.3V is not connected by default. The PSU in the original Quadra 630 PSU uses this wire for ground. While the motherboards I tested did not actually connect this wire, I have left it not connected by default. If you need 3.3V, bridge the "ATX 3V3" jumper.
  • I can't a good connector for the 6-pin "MAC-AUX" connector. The BOM references the best fitting part although the smaller wall has to be cut in order for the connector to fit.
  • PCB was designed with 2oz copper in mind.

License and Copyright

Copyright © Dean Winger 2021

This work is licensed under the Creative Commons Attribution-ShareAlike 4.0 International License. To view a copy of this license, visit http://creativecommons.org/licenses/by-sa/4.0/ or send a letter to Creative Commons, PO Box 1866, Mountain View, CA 94042, USA.

About

ATX - Quadra 630 PSU Conversion Kit

Resources

License

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published