BILL OF MATERIALS

The code has been designed to be plugable, meaning there is a minimal hardware configuration one can start with if certain features are not something of interest, it's all appropriately split under "BASE" or "EXTENDED" functionality (see bellow).

BASE FUNCTIONALITY

---

• Arduino Nano AT328
  • Arduino Nano expansion board
• 2.4" Nextion LCD
• MAX6675 thermocouple
• C-M4 screw K-Type thermocouple sensor
• 40DA SSR Relay
• Thermo-resistant cables AWG15 and AWG20 ( 1m black/red ) and AWG26 ( 5m black/red/yellow/blue )
• Spade connectors M/F 6.3mm
• Power Supply:
  • 12v/1A Power Supply and 12v to 5v stepdown (these two should only be used together)

EXTENDED FUNCTIONALITY

---

• RobotDYN dimmer module - Dimmer 4A-400V
• Pressure sensor - 0-1.2Mpa
• GC specific:
  • Fitting - 6-02/PCF
  • Transducer Fitting - 6mm/PE
  • Hose - 6x4 - 1 meter
  • 1-Bit AC 220V Optocoupler
• GCP specific:
  • Hose - 4mm x 9mm
  • Transducer Fitting - 6mm x 1/4
  • T-fitting - 6mm
  • Clamps - 100pcs and plier

Housing variants:

• Gaggiuino v1
• Gaggiuino v2

Cheap services to order the prints if not owning a printer:

• cloudcraft3d.com