We read every piece of feedback, and take your input very seriously.
To see all available qualifiers, see our documentation.
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
In Axis if you configure DISPLAY OPEN_FILE = "" to not load a default file and press the run button after homing you get a blank error pop up message.
LinuxCNC 2.7.4
The text was updated successfully, but these errors were encountered:
rs274ngc_pre.cc msg for INTERP_FILE_NOT_OPEN
bbfb9fb
Re: Blank Error Message #63 Signed-off-by: Dewey Garrett <dgarrett@panix.com>
This bug is fixed in 2.7 by http://git.linuxcnc.org/gitweb?p=linuxcnc.git;a=commitdiff;h=bbfb9fbd2d06648fcc624fb1bae46dd46cc3ca77 and tested by me
Sorry, something went wrong.
No branches or pull requests
In Axis if you configure DISPLAY OPEN_FILE = "" to not load a default file and press the run button after homing you get a blank error pop up message.
LinuxCNC 2.7.4
The text was updated successfully, but these errors were encountered: