default_grbl_settings.gcode

;Step Pulse, us;
$0=10
;Step idle delay, ms;
$1=255
;Step port invert, mask;
$2=0
;Direction port invert, mask;
$3=0
;Step enable invert, boolean;
$4=0
;Limit pins invert, boolean;
$5=0
;Probe pin invert, boolean;
$6=0
;Status report, mask;
$10=0
;Junction deviation, mm;
$11=0.010
;Arc tolerance, mm;
$12=0.002
;Report inches, boolean;
$13=0
;Homing cycle, boolean;
$22=1
;Soft limits, boolean;
$20=1
;Hard limits, boolean;
$21=1
;Homing dir invert, mask;
$23=1
;Homing feed, mm/min;
$24=100.000
;Homing seek, mm/min;
$25=750.000
;Homing debounce, milliseconds;
$26=250
;Homing pull-off, mm;
$27=1.000
;Max spindle speed, RPM;
$30=1000
;Min spindle speed, RPM;
$31=0
;Laser mode, boolean;
$32=1
;X steps/mm;
$100=100.000
;Y steps/mm;
$101=100.000
;X Max rate;
$110=9000.000
;Y Max rate;
$111=5000.000
;X Acceleration;
$120=1500.000
;Y Acceleration;
$121=1000.000
;X Max travel, mm;
$130=130.000
;Y Max travel, mm;
$131=130.000
;Default homing offset for Engravinator
G10 L2 P1 X0 Y-130