Seven Deadly Sins Watch Faces for Your wearOS Watch
- watch with wearOS 2.0 and higher
- Windows PC
The only interface that allows us to manage the watch more flexibly is only ADB via Wi-Fi, so we need to activate it in the watch settings.
Open the settings on your watch and go to "About watch" -> "Software info".
Find "Software version" and tap on it until you get the message "Developer mode turned on".
Now, among the settings items, the "Developer Settings" item has appeared.
Go to "Developer Settings" and enable "ADB Debugging" and "Debug over Wi-Fi".
Wait until the watch shows its own IP address to connect.
Excellent. Your watch is ready to connect to your PC and install watch faces.
In order for a computer to connect to your watch, it must be connected to the same Wi-Fi network.
Download the archive with the installer and watch faces if you haven't done it before. Copy the folder from the archive to any place convenient for you.
Run the file install.bat.
Enter the IP address you received from the watch in the developer options and press enter.
If you did everything right and entered the IP address correctly, you will see a message on the command line that the connection to the watch was successful, and a screen with the question "Allow Debugging?" will appear on the watch. In the pop-up window, click "Always allow from this computer".
To start installing watch faces, simply press enter again. At the end of the installation, the installation window closes automatically.
The only thing left is - to apply your new watch face
Go to the watch face selection mode by holding anywhere on the main screen, and go to the end of the list to the "Add watch face" button.
In the list that appears, find the watch faces you just installed and apply them by simply tapping on them.
