You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
When opening the program, channel 1 probe's scaling is set to 10x, as I left it. But in order to the measures to be correck I have to uncheck and check the box again.
Also, is it possible to use custom attenuation probes? I'm plannig to make some DIY 4:1, 20:1 and 50:1 probes.
Steps to reproduce the behavior:
Open the program
Check 10x at both channels
Close the program and open again
See that channel 1 in left lower corner is not corresponding to the scale set in the control panel
Device Hantek 6022BE
The text was updated successfully, but these errors were encountered:
Hi,
When opening the program, channel 1 probe's scaling is set to 10x, as I left it. But in order to the measures to be correck I have to uncheck and check the box again.
Also, is it possible to use custom attenuation probes? I'm plannig to make some DIY 4:1, 20:1 and 50:1 probes.
Steps to reproduce the behavior:
The text was updated successfully, but these errors were encountered: