-
Notifications
You must be signed in to change notification settings - Fork 109
Network Configuration
lthursdayl edited this page May 4, 2015
·
7 revisions
This section will cover the basic configuration of the Gigabit network which the OpenPTrack master and all peers need to be connected to. Further more the basic best practices to be used regarding networking.
We have found that using a topology and IP configuration similar to that shown below works reliably:
Note: In our typical setups, the SwissRanger is on a second network interface (NIC) card, allowing it to be on a separate segment (This is done to conserve bandwidth on the OPT LAN, and is particularly important for high-bandwidth devices like the Point Grey GigE cameras.)
If you are working with OpenPTrack v2, use this wiki instead.
- Time Synchronization
- Pre-Calibration Configuration
- Intrinsic Calibration
- Camera Network Calibration
- Person Tracking
- Object Tracking
- World Coordinate Settings
- Tips and Tricks
- Tested Hardware
- Network Configuration
- Imager Mounting and Placement
- Calibration in Practice
- Quick Start Example
- Imager Settings
- Manual Ground Plane
- Calibration Refinement
How to receive tracking data in:
Notes on contributing to OPT.