Skip to content

AVR: Compiling

Jump to bottom
Paciente8159 edited this page Apr 10, 2022 · 8 revisions

µCNC for AVR can be built in a several ways

Method one - PlatformIO (preferred)

  1. Get Visual Studio Code and install it.
  2. Install the PlatformIO extension.
  3. Open uCNC folder in VSCode.
  4. Edit cnc_config.h file and cnc_hal_config.h file to fit your needs and board.
  5. f needed edit the platformio.ini file environment for your board. Compile the sketch and upload it to your board.

Method two - Arduino IDE (easiest)

WARNING: Arduino IDE will produce a larger output file. The makefile method has better compilation optimizations that produce a smaller binary file. With that in mind remember that some options can be activated using the makefile and others won't fit the device flash in Arduino IDE (UNO is already near max capabilities).

  1. Get Arduino IDE and install it.
  2. Go to uCNC folder and open uCNC.ino sketch.
  3. Edit cnc_config.h file and cnc_hal_config.h file to fit your needs and board.
  4. Compile the sketch and upload it to your board.

Method three - Using the makefile (optimized alternative)

  1. Download and install GCC tools for AVR inside your PC. You can download the latest version of GCC tool for AVR from Microchip from here.
    • If your are compiling with this method on a Windows machine you will also need to install Make. You can download Make for Windows from here and CoreUtils here.
  2. Go to the uCNC folder and edit the board cnc_config.h file and cnc_hal_config.h file to fit your needs and board. µCNC is configured by default to mimic Grbl pin configuration in the Arduino UNO board.
  3. Go to the makefiles/avr folder.
    • The makefile is configured by default to compile the code for the MCU (atmega328p) and working frequency (16Mhz) in Arduino UNO board. If the chosen board has a different MCU/working frequency the makefile must be adjusted by modifying CPU = atmega328p and FREQ = 16000000UL
  4. Open a command console inside makefiles/avr folder and run make clean all
  5. If everything went well you should have a hex file inside makefiles/avr/build folder
  6. Now just upload µCNC to your board using an appropriate tool. xLoader for AVR is an easy tool to use.

µCNC is free software: you can redistribute it and/or modify it under the terms of the GNU General Public License as published by the Free Software Foundation, either version 3 of the License, or (at your option) any later version. µCNC is distributed WITHOUT ANY WARRANTY.

Also without the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for more details.

µCNC Wiki

µCNC for ALL MCU

µCNC for AVR

µCNC for STM32F1 and STM32F4

µCNC for SAMD21

µCNC for ESP8266

µCNC for ESP32

µCNC for NXP LPC176x

µCNC for NXP RP2040

Clone this wiki locally