Releases: Pelochus/Ender3-V2-Config
Releases · Pelochus/Ender3-V2-Config
Pelochus Marlin 1.1
Based on the @mriscoc Ender 3 V2. Added:
- New: Changed default max Z and Extruder speeds from 10 to 20 and 45 to 100 mm/s respectively
- New: Changed default max accelerations from 500, 500, 100 and 1000 to 2500, 2500, 200 and 3000 (X, Y, Z, E)
- New: Changed default accelerations from 500 to 750 (axes), 800 to 1000 (retractions) and 1000 to 1500 (travel)
- New: Changed default BLTouch probe offset to this link's recommendations: https://www.thingiverse.com/thing:4462870
- New: Reduced max Z height to 220 due to physical constraints on my machine
- New: Changed default ESteps from 93 to 139, since I have a dual drive full-metal extruder
- New: Mildly optimised defaults for firmware retractions (shorter lengths, slightly faster)
- New: Enabled power-loss recovery by default
From previous releases:
- For 4.2.2 with RE chip
- BLTouch with UBL
- 300 max temperature for hotend
- Added some extra preheat profiles from the default from @mriscoc
- Changed some names like version and printer name