Skip to content

A Raspberry Pico MIDI player that plays physical (toy) instruments via servos.

License

Notifications You must be signed in to change notification settings

SMerrony/MidiBanger

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 

History

25 Commits
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Repository files navigation

MidiBanger

A Raspberry Pico* MIDI device that plays physical (toy) instruments via servos.

MidiBanger supports both percussive (mallet-type) and pressed (key-type) instruments.

  • Pan-and-tilt mode using just two servos to play reachable notes
  • Servo-per-note mode
  • Solenoid-per-note mode (soon)

The current version supports up to 16 directly-connected servos, later versions may support I2C servo controllers allowing hundreds of servos to be used.

*Tested on Raspberry Pi Pico, Raspberry Pi Pico W, and Waveshare RP2040-Zero.

Pan-and-tilt version playing Janod toy glockenspiel

Hardware Requirements

  • Raspberry Pico or compatible such as RP2040-Zero
  • Servo per note eg. SG90 9g Micro Servo, or a pair if using pan-and-tilt
  • Optional - Micro speaker - handy for debugging and setup
  • Optional - 5V PSU for servos, if you think you need it
  • Some 3D-printed parts to hold servos etc.

Some sample 3D parts are included in the 3D directory, there are FreeCAD designs and .3mf files for slicing.

Configuration

See the comments in src/config.h for details.

To avoid masses of commented-out congfiguration I have put the configuration that is specific to a particular physical instrument in a separate file which is then #included in the main config.h. Example configurations are chicco_toy_glock_config.h and janod_toy_glock_config.h.

For the servo-per-note mode, the critical configuration item is the NOTEPIN_INITIALISER. Leave its first line alone, then replace the contents with a maximum of sixteen [MIDI note number] = GPIO_PIN pairs.

For the two-servo pan-and-tilt mode it's the NOTE_PAN_INITIALISER that you will need to adjust to set the angles for each note. This will be a trial-and-error process, I suggest you start by installing the servos so that their centres of movement roughly point to the middle of the instrument and then do a first run WITHOUT the hammer attached.

If you are connecting up several MidiBangers I suggest you use a different string or number for each one at the end of the USB_PRODUCT string. It will make your life a lot simpler!

Building

Don't forget to set PICO_BOARD to match your target microcontroller in CMakeLists.txt, then...

mkdir build
cd build
cmake ..
make

Hints

Pan-and-Tilt Players

  • Try a metal-geared servo for the panning action, these seem to have less play than the plastic-geared equivalent.
  • For greater accuracy playing large intervals (leaps) you can try setting the angles for the lowest and highest notes just a little towards the centre, this will compensate for some overshoot.

About

A Raspberry Pico MIDI player that plays physical (toy) instruments via servos.

Topics

Resources

License

Stars

Watchers

Forks

Releases

No releases published