You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
After doing testing with various gases and various environments, I usually get this output:
The concentration of NH3 is 0.99 ppm
The concentration of CO is 1.20 ppm
The concentration of NO2 is 1.18 ppm
The concentration of C3H8 is 1000.04 ppm
The concentration of C4H10 is 999.98 ppm
The concentration of CH4 is 2991.14 ppm
The concentration of H2 is 1.09 ppm
The concentration of C2H5OH is 1.40 ppm
It seems that other than the NO2 output, the rest of the output stays as the default values and does not vary with increase or decrease of concentration of those gases. Is this a hardware issue or a firmware issue?
The text was updated successfully, but these errors were encountered:
Hello, sorry just made a mistake to close all of the issue of this library.
Please try calibrate the sensor in the fresh air again.
Are you sure the are around you contains the gas that didn't active?
Thanks.
After doing testing with various gases and various environments, I usually get this output:
The concentration of NH3 is 0.99 ppm
The concentration of CO is 1.20 ppm
The concentration of NO2 is 1.18 ppm
The concentration of C3H8 is 1000.04 ppm
The concentration of C4H10 is 999.98 ppm
The concentration of CH4 is 2991.14 ppm
The concentration of H2 is 1.09 ppm
The concentration of C2H5OH is 1.40 ppm
It seems that other than the NO2 output, the rest of the output stays as the default values and does not vary with increase or decrease of concentration of those gases. Is this a hardware issue or a firmware issue?
The text was updated successfully, but these errors were encountered: