Slow tool entry when using inches

[memsengineer]

I am using fusion 360 on windows 7 driving a Shapeoko 3 CNC router. I am using sourcerabbit 1.2.0

When I use inches in fusion 360, the tool moves as expected above the stock to the entry point. Then the tool begins to spiral into the stock very very slowwwly.

I experimented a bit and switched fusion 360 to millimeters. Now it seems to work correctly. The tool entry spiral is the expected speed.

Am I doing something else wrong with fusion 360 or is it really a source rabbit issue? I googled pretty hard but could find no one else reporting this.

[nsiatras]

Hello, I believe that issue has to do with the post processor you are using. The SourceRabbit GCode sender just sends the GCode to the controller.

…

On Wed, Oct 3, 2018 at 5:12 AM memsengineer ***@***.***> wrote: I am using fusion 360 on windows 7 driving a Shapeoko 3 CNC router. I am using sourcerabbit 1.2.0 When I use inches in fusion 360, the tool moves as expected above the stock to the entry point. Then the tool begins to spiral into the stock very very slowwwly. I experimented a bit and switched fusion 360 to millimeters. Now it seems to work correctly. The tool entry spiral is the expected speed. Am I doing something else wrong with fusion 360 or is it really a source rabbit issue? I googled pretty hard but could find no one else reporting this. — You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub <#10>, or mute the thread <https://github.com/notifications/unsubscribe-auth/AFvq7m8wAZPVNp1DFe78vk5U2mkSf-XIks5uhB0qgaJpZM4XFLT7> .