Really Very Slow import of .stl files

[redzabu]

Cura Version

5.7.1

Operating System

Fedora40 Wayland

Printer

Creality Ender 3 s1 pro

Reproduction steps

Starting fresh cura appimage - OK - loads in less than 20 sec ...
Load a simple testcube .stl file takes more than 90 sec on an AMD7 7 PRO 6850H with Radeon Graphics ?!?!
This behaviour is consistent across 3 machines (2 AMD 7 and 1 I5)

Actual results

import of a simple .stl file in a few seonds

Expected results

Import takes AGES!

Add your .zip and screenshots here ⬇️

[Asterchades]

Without the affected STL to replicate the issue there isn't going to be a great deal that can be done about this. It could be a corrupted or faulty file, or it could be an edge case which has implications elsewhere but hasn't been nearly as obvious an issue to investigate.

[CrashTD]

Likely dublicate of #18968?

Check if disabling USB Printing fixes the issue. This is of course no permant solution.

[redzabu]

Spot on ! disabled USB printing and ... problem solved For now i'm happy again - Thanks !

…

On 28/05/2024 10:10, CrashTD wrote: Likely dublicate of #18968 <#18968>? Check if disabling USB Printing fixes the issue. This is of course no permant solution. — Reply to this email directly, view it on GitHub <#19139 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AI2GHBGPR2FLLBZTK5R4WMLZEQ3XLAVCNFSM6AAAAABIKDFQJKVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDCMZUGU4TSMZSGI>. You are receiving this because you authored the thread.Message ID: ***@***.***>

[kafufafu]

Could this have had any relation with the following? #19186

[ShyneTurtle]

Fedora 40 Wayland (asahi linux, aarch64) on cura 5.4, had the same problem and disabling USB printing fixed it.