Turn on your PC with an RFID scanner
Set IDs in the 'IDs' to will allow specified IDs to turn your device on. Add the MAC address for the PC you are want to turn on.
| Pin | Wiring |
|---|---|
| SDA | Digital 10 |
| SCK | Digital 13 |
| MOSI | Digital 11 |
| MISO | Digital 12 |
| IRQ | Unconnected |
| GND | GND |
| RST | Digital 9 |
| 3.3V | 3.3V |
To get your custom RFID ID you will need to connect your controller to your PC via USB. In the Arduino IDE select the correct board and COM port. Go to File > Settings > FRC522 > DumpInfo. Upload this file. Once upload is finished you will be able to scan your RFID device and get the ID. When the information prints out to serial you will find "Card UID: YOUR_CODE_HERE". This is the ID that you will need to add to your IDs variable on line 6 of main.py.
Open Command Prompt on the device you are wanting to WOL. Type 'ipconfig /all'. Here you will want to look for the device and find 'Physical Address'. This is what you will want to replace to main.pyon line 13 where it says 'YOUR_DEVICE_MAC_ADRESS'.