You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Since this part is a mid-mount connector, it requires a board cutout to get out of the way of the connector's underside. At least that's how I read the scored line on the datasheet.
I'm pretty sure that in your footprint, the F.Fab layer shows what the board cutout should be. When you're placing this part, do you manually add edge cuts that conform to those lines? Or is there a more automatic and less error-prone way to do it?
Sorry if this isn't the right forum for asking a tech-support question. If there's a better way, please let me know.
The text was updated successfully, but these errors were encountered:
Since this part is a mid-mount connector, it requires a board cutout to get out of the way of the connector's underside. At least that's how I read the scored line on the datasheet.
I'm pretty sure that in your footprint, the F.Fab layer shows what the board cutout should be. When you're placing this part, do you manually add edge cuts that conform to those lines? Or is there a more automatic and less error-prone way to do it?
Sorry if this isn't the right forum for asking a tech-support question. If there's a better way, please let me know.
The text was updated successfully, but these errors were encountered: