This is a collection of random breakout boards I developed to get started with a new device.
Firmware for the SAM D11 used as a debugger/VCP interface on some boards is available here)
- Atmel SAME70 / SAMS70
- ST STM32G071
- GigaDevice GD32F407V (will probably work for STM32F407 as well)
- Lattice LCMXO256C
- Lattice LCMXO2-2000HC
- Nuvoton M484SIDAE
- Atmel SAMD11 USB Test Board
- Raspberry Pi RP2040
The boards are added here at the same time they are submitted for fabrication. There may be issues with them, but I will not know about them until the boards arrive. Those issues will not be fixed in the files, unless the boards are really broken and I need to reorder them, or I want to reorder them for some other reason.
Below is a list of known issues:
- GD32F407V - BOOT0 (pin 94) should be pulled down by a 10 kOhm resistor. This is an easy fix, there is a groud pour near the jumper.
- SAMD11 USB Test Board - Switch footprint is slightly off (mounting pads are wider than on a real switch).