You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
From what I can see in the SS24FL datasheet, it measures a maximum of 3.90 x 1.95mm. Maybe double-check where the 5.40 x 1.80mm size you've mentioned comes from, as I couldn't find it.
The pads we have are a little smaller than the recommended footprint and don't extend beyond the diode's leads, but we haven't had any trouble with soldering these parts (reflow has always worked fine and I've assembled/reworked a number of boards by hand without noticing a problem here). We've used this same footprint & part since V1.1 of the RUMBA+ boards, and I don't believe we've ever seen a problem with these diodes - so I don't think you will run into any trouble there.
I'll take a look at the pads during the next revision, but I'm hesitant to do a revision just for this as it's always worked without issue.
Hi Chris,
i think thats wrong or?
D3, D4, D5, D15, the BOM component size is 5.4 * 1.8mm, while Gerber pad size is 3.7 * 1.2mm, not match.
The text was updated successfully, but these errors were encountered: