A NodeJS app to control and keep stats on a Greyko pellet burner through it's serial port
If you're wondering about the project name, here's a short explanation :)
pamno
- [pam-no] - noun:Translation from Bulgarian - central heating for the house.
Also my son's favorite thing in his grandparent's house.
The app communicates with the pellet burner through it's RS232 port.
- A Greyko RB-20 pellet burner. Might work on other models too, but this is the one we tested with
- A RS232 to USB converter cable
- !!! Important: Some cables send the burner controller in a boot loop! It's important to disconnect the cable immediately if you notice the burner or its controller acting strange!
- A fix that we found out to work was to build a small direct (pin to pin, without crossing) "extension" cable that only connects pins 2,3 and 5 (Rx, Tx, GND) on the DB9 connector.
- A computer to run the app on. A desktop computer, a laptop or a Single-Board-Computer like Raspberry PI.
- An InfluxDB instance if you want data logging
TBD
TBD