-
Notifications
You must be signed in to change notification settings - Fork 2
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
CNC probleme mit der Referenzfahrt #101
Comments
Hmmm, das software update sollte damit nichts zu tun haben. Da ging es ja nur um das control panel. Und es wurde auch nur da etwas geändert.
Ich hatte das aber auch schonmal. Bei mir war da irgendein Problem mit den endstopps. Die fräse dachte also, dass sie die endstopps schon getriggert hatte... Was geholfen hatte war, die endstopps mal manuell zu drücken und die fräse komplett aus und wieder einzuschalten.
Wichtig beim aus und wieder einschalten ist nur, dass man auch den pi von der fräse trennt oder runter fährt. Sonst versorgt der den Controller weiterhin mit Strom.
…________________________________
From: Johannes <notifications@github.com>
Sent: Sunday, March 17, 2019 3:51:45 AM
To: comakingspace/do-something
Cc: NitramLegov; Mention
Subject: [comakingspace/do-something] CNC probleme mit der Referenzfahrt (#101)
Die CNC führt den Referenzfahrt Befehl nicht richtig es wird nur die Z Achsen Endstop wird abgefahren.
Ich vermute es könnte was mit dem letzten Software update zu tun hat. @Narquadah<https://github.com/Narquadah> @NitramLegov<https://github.com/NitramLegov>
—
You are receiving this because you were mentioned.
Reply to this email directly, view it on GitHub<#101>, or mute the thread<https://github.com/notifications/unsubscribe-auth/AHcoi3fCnRuAepnOZCVa61FXIvGbkaOqks5vXa3BgaJpZM4b4Jat>.
|
@Johannes09 das Problem war am Freitag nicht mehr da, oder? Also bevor #104 aufgetreten ist...dann könnten wir hier wieder zumachen. Wenn das öfter auftritt und @NitramLegov s Tipp geholfen hat, sollte es allerdings in die Einweisung der CNC-Fräse aufgenommen werden, findet ihr nicht? |
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Die CNC führt den Referenzfahrt Befehl nicht richtig es wird nur die Z Achsen Endstop wird abgefahren.
Ich vermute es könnte was mit dem letzten Software update zu tun hat. @Narquadah @NitramLegov
The text was updated successfully, but these errors were encountered: