Laser cutter focusing laser is out of calibration

[kenomaerz]

Yesterday, @Pakue95, @NitramLegov and I found, that the laser cutter focusing help is not calibrated correctly. To achieve best focus, you need to aim the calibration help ~5mm to the right of the actual laser beam, which is not quite optimal.

We probably need to contact the manufacturers for a fix.

[LukasFreeze]

How exactly is the focusing supposed to work for this machine? Is it not possible to adjust the calibration help?

…

On Thu, Jun 25, 2020 at 1:35 PM Keno März ***@***.***> wrote: Yesterday, @Pakue95 <https://github.com/Pakue95>, @NitramLegov <https://github.com/NitramLegov> and I found, that the laser cutter focusing help is not calibrated correctly. To achieve best focus, you need to aim the calibration help ~5mm to the right of the actual laser beam, which is not quite optimal. We probably need to contact the manufacturers for a fix. — You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub <#203>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AEWXG266IGGBSOD7M3PDKNTRYMZBFANCNFSM4OII4FFA> .

[NitramLegov]

@Johannes09 and me took a look at the calibration help (laser pointer) and adjusted it a bit. We'll need to check whether it was enough or not.

[LukasFreeze]

We'll need to check whether it was enough or not.

Did that work?

[kenomaerz]

I have been using Patrick's calibration helper and have been getting good results. I'll close this for now.