nRF24L01 multi-protocol RC transmitter
- source code from this project:https://github.com/goebish/nrf24_multipro
- porting it to Arduino Leonardo
- verified with FrSky X9D plus and JJ1000 Quadcoper
=========================================================================
Create a model in OpenTX using external module in PPM mode, 12 channels and TAER sequence order.
#####Protocol is selected with stick position at startup:
Rudder right + Elevator down = HiSky RXs, HFP80, HCP80/100, FBL70/80/90/100, FF120, HMX120, WLToys v933/944/955
Rudder right + Elevator up = Syma X5C (older model), X2 ...
Rudder right + Aileron right = MJX X600
Rudder right + Aileron left = EAchine H8 mini 3D, JJRC H20/H22
Elevator down + Aileron left = Syma X5C-1/X11/X11C/X12
Elevator down + Aileron right = Attop YD-822/YD-829/YD-829C ...
Elevator up + Aileron right = EAchine H8(C) mini, BayangToys X6/X7/X9, JJRC JJ850, Floureon H101 ...
Elevator up + Aileron left = EAchine H7
Elevator up = WLToys V202/252/272, JXD 385/388, JJRC H6C, Yizhan Tarantula X6 ...
Elevator down = EAchine CG023/CG031/3D X4
Aileron left = Cheerson CX-10 green pcb
Aileron right = Cheerson CX-10 blue pcb & some newer red pcb, CX-10A, CX-10C, CX11, CX12, Floureon FX10, JJRC DHD D1
Last used protocol is automatically selected if stick is in neutral position.
#####Extra features (if available on aircraft):
Channel 5: led light, 3 pos. rate on CX-10, H7, inverted flight on H101
Channel 6: flip control
Channel 7: still camera
Channel 8: video camera
Channel 9: headless
Channel 10: calibrate Y (V2x2), pitch trim (H7), RTH (H8 mini/H20), 360deg flip mode (H8 mini 3D/H22)
Channel 11: calibrate X (V2x2), roll trim (H7)
Channel 12: Reset / Rebind