This repository has been archived by the owner on May 15, 2023. It is now read-only.
-
Notifications
You must be signed in to change notification settings - Fork 3
Recommended Hardware
nzbullet edited this page Mar 27, 2020
·
1 revision
The below list is the Hardware I use for my Alarm and can recommend them first hand.
- Raspberry Pi 4 model B (4GB): To run Homebridge and MQTT Server
- Sonoff RF Bridge: Flashed with Tasmota. Receives 433Mhz RF Messages from sensors and sends to MQTT.
- Indoor PIR Sensor: 433Mhz Wireless Indoor PIR - Model CT60
- Outdoor PIR Sensor: 433Mhz Wireless Waterproof Outdoor PIR - Model CT70
- Digoo Door and Window Sensor: Digoo 433MHz Door & Window Alarm Sensor
- Digoo Siren: Digoo DG-ROSA 433MHz Wireless DIY Standalone Alarm Siren
- Digoo Keyfob: Digoo DG-HOSA Wireless Remote Controller (Black or White)
- Maximum of 4 Keyfobs can be linked to the RF Bridge
- You don't need to have a siren to use a keyfob with HomeKit, however, you do need to have a keyfob to use a siren
- The Sonoff RF Bridge will receive codes from a keyfob on the same topic as the sensors without any linking.
- If you have a siren you need to link your Keyfob to both your Sonoff RF Bridge and the Siren.
- Once linked you will be able to arm, disarm or trigger the siren from the keyfob and/or HomeKit.
- To link the keyfob to the siren follow the instructions of the siren
- To link the remote to the RF Bridge (to be able to use the siren with HomeKit) publish the value
2tocmnd/rfbridge/rfkeyX(replace X with a value from 1-16) then press the button on the remote you wish to link (e.g. Away Arm or SOS etc).