---

Installation:

wget -q https://raw.githubusercontent.com/dashfirst/dashfirst_mn/master/dashfirst_install.sh
bash dashfirst_install.sh

---

Desktop wallet setup

After the MN is up and running, you need to configure the desktop wallet accordingly. Here are the steps for Windows Wallet

1. Open dashfirst Core Wallet.
2. Go to RECEIVE and create a New Address: MN1
3. Send 3000 DFCN to MN1.
4. Wait for 15 confirmations.
5. Go to Tools -> "Debug console - Console"
6. Type the following command: masternode outputs
7. Go to Tools -> "Open Masternode Configuration File"
8. Add the following entry:

Alias Address Privkey TxHash Output_index

• Alias: MN1
• Address: VPS_IP:PORT
• Privkey: Masternode Private Key
• TxHash: First value from Step 6
• Output index: Second value from Step 6

9. Save and close the file.
10. Go to Masternode Tab. If you tab is not shown, please enable it from: Settings - Options - Wallet - Show Masternodes Tab
11. Click Update status to see your node. If it is not shown, close the wallet and start it again. Make sure the wallet is un
12. Select your MN and click Start Alias to start it.

---

Usage:

dashfirst-cli mnsync status
dashfirst-cli getinfo
dashfirst-cli masternode status #This command will show your masternode status

Also, if you want to check/start/stop dashfirst , run one of the following commands as root:

systemctl status dashfirst #To check the service is running.
systemctl start dashfirst #To start dashfirst service.
systemctl stop dashfirst #To stop dashfirst service.
systemctl is-enabled dashfirst #To check whetether dashfirst service is enabled on boot or not.

---

Issues:

If your dashfirst Core Wallet doesn't sync, go to Tools -> Open Wallet Configuration File and add the following entries:

addnode=188.225.75.223
addnode=188.225.75.225
addnode=188.225.75.226
addnode=188.225.75.224