SMA Hybrid: Nach Start von evcc wird Zähler im WR nicht mehr gefunden #11802
-
Eingesetzt wird der SMA Sunny Tripower 10.0 Smart Energy Hybrid Wechselrichter und der SHM 2.0. Der Zähler ist im WR per Speedlink verbunden. Sobald evcc (im Docker Container) gestartet wurde, wird der Zähler nicht mehr gefunden. Habe ich da etwas falsch konfiguriert? Oder ist das ein bekanntes Problem? Konfiguration ist:
|
Beta Was this translation helpful? Give feedback.
Replies: 3 comments 19 replies
-
Du brauchst den Host Network mode. Siehe den SMA Tab unter https://docs.evcc.io/docs/installation/docker |
Beta Was this translation helpful? Give feedback.
-
Danke für den Hinweis! Den habe ich aber (auf einer Synology) in Verwendung. Die Kommunikation zwischen evcc und SHM / WR funktioniert ja auch. Die Daten werden korrekt angezeigt. Nur im WR bekomme ich die Fehlermeldung "Störung der Kommunikation zur Zählereinrichtung (7619)". Und der Zähler ist da per Speedwire angebunden. |
Beta Was this translation helpful? Give feedback.
-
Hm. Auf den ersten Blick finde ich da nichts. Sowohl die SMA Komponenten als auch die Synology hängen direkt an einer Fritzbox. Und dort sehe ich auch keine Logeinträge die auf Probleme mit Multicast / IGMP hindeuten. Die Fritzbox läuft mit der aktuellen Version. Es gibt zwar im Netzwerk ein unmanaged Netzwerk-Switch. Aber das hängt nicht dazwischen. Was mich wundert ist, dass sobald evcc läuft ich den Fehler im WR sehe. Wenn evcc aber wieder gestoppt ist, habe ich den Fehler nicht mehr. |
Beta Was this translation helpful? Give feedback.
Nein, ist normalerweise immer nur Multicast.
Es sei denn im Sunny Portal wurden IPs für Unicast eingetragen.
Aber das Problem liegt hier in einer fehlerhaften IGMP-Funktion oder -Konfiguration.