You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I'm a new user of CFAST. I have some problems in inputing the file in the compartment Sheet.
I'm creating a non adiabatic thermal problem.
In the lower part of the window, where i have to enter cieling wall and floor thickness linking to the materia defined in in previous sheet "Thermal properties", the software does not recognize the input. For example, if I insert 0.20m for the wall thickness, the software defines it as 0m.
I tryed also to write 0,20 insteand 0.20 (with comma "," instead of dot ".") but I'm having the same problem.
Than if i save the project, i can't open again because the sw gives the error in attachment,
I'm a european user, so i'm using the EU keybord setting on the PC.
Are there any special setting to check for EU users?
Does anyone have suggestion?
Attacking some screen of the software.
Thanks for any suggestion,
Marco
The text was updated successfully, but these errors were encountered:
Step one) you have to use the American settings for the keyboard. CFAST doesn't recognize the EU settings. Numbers must have a . and not a , and so forth. Sorry about that.
Goodmorning,
I'm a new user of CFAST. I have some problems in inputing the file in the compartment Sheet.
I'm creating a non adiabatic thermal problem.
In the lower part of the window, where i have to enter cieling wall and floor thickness linking to the materia defined in in previous sheet "Thermal properties", the software does not recognize the input. For example, if I insert 0.20m for the wall thickness, the software defines it as 0m.
I tryed also to write 0,20 insteand 0.20 (with comma "," instead of dot ".") but I'm having the same problem.
Than if i save the project, i can't open again because the sw gives the error in attachment,
I'm a european user, so i'm using the EU keybord setting on the PC.
Are there any special setting to check for EU users?
Does anyone have suggestion?
Attacking some screen of the software.
Thanks for any suggestion,
Marco
The text was updated successfully, but these errors were encountered: