improve table saw

[LukasFreeze]

The table saw is usable now, so #66 is closed and optional steps from there (and others) are coordinated here to further improve its performance and safety.

• glue 3D printed foot to leg (currently piece of duct tape)
• attach pieces of anti-slide mat to the feet
• get blade change tools from previous owner
• replace all PH screws with internal hex screws for less cam-out (two cylindrical heads for the ends of the sled grooves, eight countersunk screws for the red plastic surrounding the blade - all probably M4 x 8 mm)
• improve the parallel fence - ideally longer profile to reach the opposite side of the table, second clamp and ruler in the back

[LukasFreeze]

all 10 screws are now M4 x 10 mm countersunks with internal hex drive, the matching key is magnetically attached to the left front edge of the undercarriage!

[LukasFreeze]

Any news on the blade change tools? I saw a hack/workaround online that could work in case we are not able to get a hold of the previous owner...

[emka]

I have met the previous owner again a while ago. He could not find the tools anymore and promised to contact me if he finds them. I think we should better find a replacement.

[LukasFreeze]

They should be relatively standard and can be bought along with a new blade once needed - thanks for checking anyway!

…

On Apr 27, 2017 8:23 AM, "emka" ***@***.***> wrote: I have met the previous owner again a while ago. He could not find the tools anymore and promised to contact me if he finds them. I think we should better find a replacement. — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub <#84 (comment)>, or mute the thread <https://github.com/notifications/unsubscribe-auth/AS1za0NV1wLZG0fATgc0HOK-aZr4sAUeks5r0DR8gaJpZM4KdPiX> .