Battery Attributes not working

[iamhuman2414]

How do I fix the battery attributes? They just stopped working I'm not sure when it started.

[iamhuman2414]

@sweichbr I saw your post on another issue, could you please share the instructions? I edited the binary_sensor.py in my /config/custom_components/wyzesense/ changed device_state_attributes to extra_state_attributes rebooted HA but still not working.

[sweichbr]

I found that you had to trigger each of the sensors. Probably because they don't report in unless there is an event (likely to save battery).

[onebyside]

I found that you had to trigger each of the sensors. Probably because they don't report in unless there is an event (likely to save battery).

Can you paste your fix for this problem, been awhile since the batt reported in.

[jdubz666]

Hey,

I'm having the same issue with motion and contact sensors.

My sensors suddenly stopped responded so I removed and then added them back. It worked however they came back without battery and RSI attributes.

I made sure the sensor were being triggered to initiate the attributes. And I checked back a day after to see if they are added after a delay. No luck.

I tried changing /config/custom_components/wyzesense/ changed device_state_attributes to extra_state_attributes

Strangely this fixed for the motion sensor but not the contact sensors...

Any idea for how to fix battery for contact sensors?

[onebyside]

same issue here Bell SM-G996W

…

________________________________ From: jdubz666 ***@***.***> Sent: Tuesday, February 28, 2023 10:00:57 PM To: kevinvincent/ha-wyzesense ***@***.***> Cc: onebyside ***@***.***>; Comment ***@***.***> Subject: Re: [kevinvincent/ha-wyzesense] Battery Attributes not working (Issue #227) Hey, I'm having the same issue with motion and contact sensors. My sensors suddenly stopped responded so I removed and then added them back. It worked however they came back without battery and RSI attributes. I made sure the sensor were being triggered to initiate the attributes. And I checked back a day after to see if they are added after a delay. No luck. I tried changing /config/custom_components/wyzesense/ changed device_state_attributes to extra_state_attributes Strangely this fixed for the motion sensor but not the contact sensors... Any idea for how to fix battery for contact sensors? — Reply to this email directly, view it on GitHub<#227 (comment)>, or unsubscribe<https://github.com/notifications/unsubscribe-auth/AK3CXEYK6XEX53GUAXH3WKTWZ23WTANCNFSM53UMBRFQ>. You are receiving this because you commented.Message ID: ***@***.***>