-
Notifications
You must be signed in to change notification settings - Fork 10
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Regarding Pin Mapping #4
Comments
Also I want to know where in code can i find the communication part of ESP32 with STC15W408AS. |
Did you find the firmware for STC15W408AS? |
No i didn't
…On Mon, 28 Mar 2022, 12:36 pm pegasus-automation, ***@***.***> wrote:
Did you find the firmware for STC15W408AS?
—
Reply to this email directly, view it on GitHub
<#4 (comment)>,
or unsubscribe
<https://github.com/notifications/unsubscribe-auth/AXQFU7NYGLLVMHYIYR3BZWTVCFK65ANCNFSM5NAPBZRQ>
.
You are receiving this because you authored the thread.Message ID:
***@***.***>
|
Where can I find the the firmware for STC15W408AS |
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Can you please tell me how the pins of ESP32 are mapped to driver outputs, heaters and fans i.e in schematic I can see them connected through STC15W408AS controller which is communicating with esp32 using RX/TX lines (probably UART). And in code pins of driver outputs like Step,DIR,Enable are labelled as 100,104,108,etc.
So can you please explain me how they are connected and how will I get output on the drivers using esp32.
The text was updated successfully, but these errors were encountered: