Starting navidrome.service fails with code=exited, status=203/EXEC
#2382
-
Hi all! I tried to set up Navidrome on my Raspberry Pi 3 B+ (arm64 architecture). I downloaded the tarball from the releases page (navidrome_0.49.3_Linux_arm64.tar.gz), ran the commands on the Linux Install page. The tarball got uncompressed to Running the three systemd-related commands on the bottom returns the following:
My
My
EDIT: I found out that the Raspberry Pi 3 B+ is and ARMv8 processor (taken from the Specification part of its official site). There's only a binary up until ARMv7. Does this mean I can't run Navidrome on my Pi? |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment
-
Ran |
Beta Was this translation helpful? Give feedback.
Ran
cat /proc/cpuinfo
to find out that my Raspberry Pi 3 B+ actually has an ARMv7 processor. I downloaded it and installed like the steps said.