You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I have a basic question.
Do we need to externally connect pull up resistors to establish a I2C communication ?
I see the break out board already having some SMD along with sensor and Diodes..
Are the terminals output points already having the pullup resistors ?
I am using a NXPk66F dev board.
The text was updated successfully, but these errors were encountered:
All of our breakout boards are populated with 10k pull-up resistors Looks like bme280 has a little 4 resistor array for this- that component with "103" on it is "10" + three zeros, or "10,000" Ohms.
Hi Team,
I have a basic question.
Do we need to externally connect pull up resistors to establish a I2C communication ?
I see the break out board already having some SMD along with sensor and Diodes..
Are the terminals output points already having the pullup resistors ?
I am using a NXPk66F dev board.
The text was updated successfully, but these errors were encountered: