-
Notifications
You must be signed in to change notification settings - Fork 42
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
homebrew setup reboots/crashes when in the config menu #11
Comments
Could it be that you accidentally activate sleep mode? When sleep mode is entered, the board plays beep sound four times. Afterwards the controller enters sleep mode and can be woken up with pressing the main button. As to crashing in config mode, do you have lights? Did you check your voltages? Undervoltage can cause crash. As well as memory overflow if you use too many neopixels. |
it is possible that it is undervolting, i have been using an 18650 to power it directly. I'll install a boost converter and see if that helps. for the Pixels i am using a strip of about 60. is that too many? thanks |
I don't recommend using a boost converter, it just eats more power
unnecessarily. Check the quality and rating of your battery. It needs to
be able to handle the current demand of the pixels. It could be that the
battery's protection circuit is kicking in. If you are in the US I
recommend Orbtronic, they have an 18650 rated at 10amps and 3500mah.
You can use up to 120 safely, the main issue is the memory requirements
involved. We've been working on improving the efficiency of the code, and
you may be able to go higher, but that is our current recommendation.
Jason "Kuma" Brinkerhoff
*Mad Science Workshoppe, *proprietor
http://jbkuma.com/workshoppe
…On Mon, Oct 30, 2017 at 10:37 AM, raptordemon ***@***.***> wrote:
it is possible that it is undervolting, i have been using an 18650 to
power it directly. I'll install a boost converter and see if that helps.
for the Pixels i am using a strip of about 60. is that too many?
thanks
Raptor
—
You are receiving this because you are subscribed to this thread.
Reply to this email directly, view it on GitHub
<#11 (comment)>,
or mute the thread
<https://github.com/notifications/unsubscribe-auth/ATdCML1ot4f8k7-6f-vABk1yxdlzMvdcks5sxd8ygaJpZM4QJEm7>
.
|
ok this is power related. works fine if i plug it in! thanks everyone! |
Hi, first off, i love this project, it is awesome and thanks for building it.
i have build a homebrew version as i had all the parts in stock and decided to try it for halloween.
I've run into issues where the saber crashes while going through the config menu and it just reboots. ive also had issues with not being able to navigate the menus, usually around the Sleep mode section.
have you run into this before?
thanks
Raptor
The text was updated successfully, but these errors were encountered: