You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Operating System: Windows
System Architecture: 64 bit
Windows Version: Windows 10 (build 18362), 64-bit edition
Total RAM size [MB]: 17,070MB
3D printer brand / version + firmware version (if known)
Creality Ender 3, but not related to printer IMHO
Behavior
When this particular model is sliced, I see very strange pieces of external perimeter on some layers. These pieces just stick into the air, and on some layers they are event not connected to the model at all
I played with some settings (i.e. retraction, layer height), it's completely possible it's some kind of misconfiguration, but I was not able to figure it out
I inspected the model and see nothing strange in these parts, Prusa Slicer does not report any problems, also Cura slicer make no such artifacts
I didn't encounter such behaviour in any other model
Version
Version: 2.2.0+win64
Build: PrusaSlicer-2.2.0+win64-202003211145
Operating system type + version
Operating System: Windows
System Architecture: 64 bit
Windows Version: Windows 10 (build 18362), 64-bit edition
Total RAM size [MB]: 17,070MB
3D printer brand / version + firmware version (if known)
Creality Ender 3, but not related to printer IMHO
Behavior
Project File (.3MF) where problem occurs
kazooBody.3mf.zip
kazooBody.gcode.zip
config.zip
The text was updated successfully, but these errors were encountered: