You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
The combining of infill every x layer does not do anything
I saw that this was an issue, I don't know if this is resolved? There is no mention in the manual about combining infill.
I am making a lot ( a Lot!) of small pieces, with an 0.2 nozzle, and the result is fabulous (only with slic3r, tried Cura, but not a fine result) but time could be won if infill could be combined.
Using rectilinear infill.
Feedback would be appreciated.
The text was updated successfully, but these errors were encountered:
Generally 80% of the nozzle diameter is considered practical, but infill
can be different depending on how wide you have it--but that generally gets
you into flow volume issues. Normally people just print the infill faster
rather than fatter.
Version
1.3
Operating system type + version
WIN 11 64
Behavior
The combining of infill every x layer does not do anything
I saw that this was an issue, I don't know if this is resolved? There is no mention in the manual about combining infill.
I am making a lot ( a Lot!) of small pieces, with an 0.2 nozzle, and the result is fabulous (only with slic3r, tried Cura, but not a fine result) but time could be won if infill could be combined.
Using rectilinear infill.
Feedback would be appreciated.
The text was updated successfully, but these errors were encountered: