Skip to content
v3.1.0-RAMPS
Go to file
Code
This branch is 448 commits ahead, 4096 commits behind prusa3d:MK3.

Latest commit

 addition #if to exlude unsupported microstepping code
 update configuration_prusa.h to match changes in variants/1_75mm_MK2-RAMBo13a-E3Dv6full.h
 tidy up in pins.h
37f40f5

Git stats

Files

Permalink
Failed to load latest commit information.

README.md

Original Prusa i3 MK2 Firmware

General instructions

This is the Prusa Firmware for Prusa i3 Mk2, modified to work with generic RAMPS hardware (or, better yet, a board with more mosfet outputs like MKS BASE or MKS GEN).

Configuration_prusa.h is already there, you don't need, or want, to copy a config from the variants directory.

Ideally, your board has a MOSFET on D7, and you should connect the extruder cooling fan to that (NOT the part fan). The firmware is setup for Dual Z steppers using the E1 driver. It won't matter if you use the Z driver for both either in series or parallel either.

Good luck!!!

Build instructions

Step 1

Install arduino

Step 2

Remove Liquid Crystal library from your arduino or rename it (not certain this is really necessary anymore)

Step 3

Install the arduino addon located in the root of this repo. Don't forget to install correct version! (not certain this is really necessary anymore

Step 4

Upload the firmware to board

About

Firmware for Original Prusa i3 3D printer by PrusaResearch, ported for RAMPS class boards

Resources

License

Packages

No packages published
You can’t perform that action at this time.