forked from arendst/Tasmota
-
Notifications
You must be signed in to change notification settings - Fork 0
Wemos D1 Mini
blakadder edited this page Nov 1, 2019
·
39 revisions
![](https://github.com/arendst/arendst.github.io/raw/master/media/wemos/wemos-d1-mini-pro-v1.0.0.jpg)
![](https://github.com/arendst/arendst.github.io/raw/master/media/wemos/wemos-d1-mini-v2.2.0.jpg)
![](https://github.com/arendst/arendst.github.io/raw/master/media/wemos/wemos-d1-mini-v3.0.0.jpg)
Flashing a Wemos D1 Mini with Tasmota firmware is nearly the same as for every other device.
Just connect Wemos D1 mini via USB. No action required to enter Flashmode!
In the Configuration -> Configure Module page, select Module Type: "18 Generic". After Saving the settings, the WEMOS reboots with the Generic configuration. The first time you switch to "18 Generic" you will NOT see all the options as seen in the picture below YET. You have to save "18 Generic" first and when you go there again after the reboot you get the long table where you can change all the pin's parameters. These steps are confirmed to also work with the Wemos D1 mini PRO v2.0.0.
![](https://github.com/arendst/arendst.github.io/raw/master/media/wemos/tasmota_module_config.jpg)
Wiki has moved to link on the left.