You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Hello, I would like to ask, on the premise that I did not change the hardware logic, I ran the following test output and reported an error. What may be the reason? Is it because I didn't turn on some parameter settings? Thank you very much for your answer
./scripts/run-verilator.sh conv_first_layer
*** FAILED *** (tohost = 1)
*** FAILED *** (code = 1, seed 1703053065) after 53768365 cycles
In addition, I would like to ask, if running this command fails, where will the log file be placed?
Thanks again!
The text was updated successfully, but these errors were encountered:
Hello, did you solve the issue? I'm running into the same problem.
Sorry I didn't notice your comment. After some research, I think it may be caused by the scratchpad being too small. Try to enlarge the scratchpad and run the test case again.
Hello, I would like to ask, on the premise that I did not change the hardware logic, I ran the following test output and reported an error. What may be the reason? Is it because I didn't turn on some parameter settings? Thank you very much for your answer
./scripts/run-verilator.sh conv_first_layer
*** FAILED *** (tohost = 1)
*** FAILED *** (code = 1, seed 1703053065) after 53768365 cycles
In addition, I would like to ask, if running this command fails, where will the log file be placed?
Thanks again!
The text was updated successfully, but these errors were encountered: