Skip to content

yellowagents/rattler

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 

History

7 Commits
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Repository files navigation

Network-emitting Accelerometer Protocol
=======================================

This protocol defines a means through which accelerometer-enabled devices can
send, and other devices receive, accelerometer data via an IP network.

The protocol is realtime and so is best deployed on a LAN-basis. The transport
used is UDP, because reliability is considered a convenience at best.

Encapsulation
-------------

Each datagram is encapsuled in a four-byte header::

    +---------------+---------------+-----------------+
    | uint16_t type | uint16_t size | data...         |
    +---------------+---------------+-----------------+

The type defines what kind of data the datagram contains.
See `Type definitions`_.

The size says how long *the entire datagram* is, including its header. (But of
course not including its UDP and IP headers.)

Following the two header fields is the data, which differs in structure from
message type to message type.

Message targetting
------------------

Each sending device can either broadcast the messages it sends, or unicast to a
specific pre-configured host. In the future this might be possible to do via
some means of remote configuration.

The UDP port used both for unicast and broadcast is 5612.

Type definitions
----------------

0x01, announce
  The announcement message is intended for future use as a means for devices to
  identify themselves in a human-readable fashion. It might also be that these
  messages contain device identification information. (DUID and the likes.)

  **This code is reserved.**

0x02, measurement
  The essence of the protocol, see `Measurement data`_

Measurement data
----------------

The measurement message contains four values::

    +-------------------+-----------+-----------+-----------+
    | float32 timestamp | float64 x | float64 y | float64 z |
    +-------------------+-----------+-----------+-----------+

The encoding of the floating-point data is as specified by IEEE 754, in network
order (i.e. big endian).

This means to say that the following little-endian 32-bit float ``12.34``::

    a4 70 45 41

Would be encoded on the wire as::

    41 45 70 af

The timestamp *is not* expected to be relative to any meaningful definition of
time, rather that it increments by exactly 1 for every second passed. This in
effect means that the receiver has to compensate to get human-readable
timestamps. A suggestion for how this problem is to be solved can be found in
`Ordering & time issues`_.

Accelerometer values for each axis is in units of g-force, where a value of 1.0
represents acceleration of about +1 g along that axis. When a device is
laying with its back flat on a horizontal surface, the expected values are
``(x=0, y=0, z=-1)``.

Ordering & time issues
----------------------

Because UDP is a stateless protocol and does not guarantee the order of
datagrams, it is necessary for a receiver to check the timestamps of received
datagrams to ensure that the measurement received is later than the previous.

In the reference implementation, the receiver drops measurements if they are
older than the most recent measurement. This has the side-effect that it
ensures only one device's measurements will be received and acted upon.

The reference implementation yields actual timestamps through a fairly simple
algorithm. It works by noting when the first measurement arrived and what
timestamp it had, and then compensating by that amount when the next
measurement arrives.

Of course, such a simple strategy will be desynchronized ever so slightly,
depending on the latency of the network during the transmission of that first
measurement.

About

Receiver for seismological network datagrams

Resources

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published

Languages