-
Notifications
You must be signed in to change notification settings - Fork 0
Sonoff SC
Please see the Hardware Preparation page for general instructions.
Flashing the ESP8266
Remove the 4 screws on the bottom. The button is connected to GPIO0.
You will have to remove the TX jumper in the board to avoid the ATMega328P to interfere in the upload process.
Press and hold the button while powering the board to set the ESP8266 into flashing mode. Note! After flashing you need to set the baudrate to 19200. Don't forget to reconnect the TX jumper after flashing ;)
Home
What's New
Contributing
Installation
Prerequisites
Hardware Preparation
Flashing
Initial Configuration
MQTT
Upgrading
Troubleshooting
Tutorials
FAQ
Features
Commands
Templates
Modules
Components
Rules
Smart Home Integrations
Device Configuration
Device Templates Repository
Flashing Guides
Buttons and Switches
Sensors
Lights
Displays
Useful Topics
Power Monitoring Calibration
MQTT Overview
MQTT Retained Messages
Energy Saving
Securing Your Setup
Syslog Setup
Theo's Tips
Various Tips
LEGO Nightstand Switch
For Developers
JSON Status Responses
Sensor API
Time Proportioned Output Fork
PID Control Fork