You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
But I don't know the actual steps to reupload the opencr packages? The manual simply says
How to modify ROS library code
You can modify ROS library in below paths.
Your/Arduino/Board/Package/Directory/OpenCR/hardware/OpenCR/Version/libraries/turtlebot3
Your/Arduino/Board/Package/Directory/OpenCR/hardware/OpenCR/Version/libraries/turtlebot3_ros_lib
If you want to modify it in the sketch folder, move the above two folders to the “skechbook/libraries” folder.
And I've found that path, but I can't open the .cpp in the Arduino IDE.
How do I flash these changes to the OpenCR?
The text was updated successfully, but these errors were encountered:
Hi @royito55
In order to modify the firmware in the OpenCR board manager library, you could use an editor like VSCode to open the cpp file.
Once the modification is done, the updated firmware can be uploaed to the OpenCR via Arduino IDE by selecting the example you modified.
You can find instruction in the eManual as below.
Please note that the OpenCR board manager doesn't support ARM based CPU, therefore, in order to build and upload the firmware, you should use your laptop or PC.
Thanks!
I am trying to get rid of the low voltage warning buzzer. I realized that the odometry doesn't work after this.
I followed these instructions to find where I need to deactivate the alarm:
https://answers.ros.org/question/296145/turtlebot3-low-battery-beeping/?comment=387904#post-id-387904
But I don't know the actual steps to reupload the opencr packages? The manual simply says
How to modify ROS library code
You can modify ROS library in below paths.
Your/Arduino/Board/Package/Directory/OpenCR/hardware/OpenCR/Version/libraries/turtlebot3
Your/Arduino/Board/Package/Directory/OpenCR/hardware/OpenCR/Version/libraries/turtlebot3_ros_lib
If you want to modify it in the sketch folder, move the above two folders to the “skechbook/libraries” folder.
And I've found that path, but I can't open the .cpp in the Arduino IDE.
How do I flash these changes to the OpenCR?
The text was updated successfully, but these errors were encountered: