Skip to content
New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

Sign up for GitHub

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

Jump to bottom

Cura 2.7 slicer failure #2565

Closed
tsh-xx opened this issue Oct 7, 2017 · 2 comments
Closed

Cura 2.7 slicer failure #2565

tsh-xx opened this issue Oct 7, 2017 · 2 comments

Comments

@tsh-xx
Copy link

tsh-xx commented Oct 7, 2017

The attached STL slices incorrectly. Layer 75 (sliced at 0.2mm) has no gcode.
reamer.zip

Same problem is observed with 2.6

Print actually survived, but both octoprint and gcode.ws show a problem with that layer.
@smartavionics
Copy link
Contributor

Print actually survived, but both octoprint and gcode.ws show a problem with that layer.

CraftWare and Cura itself (latest development code) do not show a problem with that layer and the gcode looks reasonable. If the gocde was actually missing the print would show an obvious line at that position, does it?

@tsh-xx
Copy link
Author

tsh-xx commented Oct 8, 2017

If i turn off 'sort layers by Z' in gcode.ws, everything looks fine.
The print had some marks (and did fail first time round) but might have been higher up on the print - so I think this is not a cura problem.

@tsh-xx tsh-xx closed this as completed Oct 8, 2017
@tsh-xx tsh-xx mentioned this issue Oct 8, 2017
Open
Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment
Assignees
No one assigned
Labels
None yet
Projects
None yet
Milestone
No milestone
Development

No branches or pull requests
2 participants
@tsh-xx @smartavionics