You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
The IP address field only allows for 16 characters. This does not allow for a port specification which is necessary for multiple printer Klipper configurations as well as for the Creality K1. The device cannot be used for these printers.
I, for instance, have three printers connected to two Klipper hosts, and a Creality K1 Max. I cannot use Knomi V2.0 with three of these printers.
Note that Knomi V1.0 allowed the port specification, so this should be considered a regression.
Thank you for your consideration. I'm keen to make use of Knomi V2.0!
The text was updated successfully, but these errors were encountered:
The IP address field only allows for 16 characters. This does not allow for a port specification which is necessary for multiple printer Klipper configurations as well as for the Creality K1. The device cannot be used for these printers.
I, for instance, have three printers connected to two Klipper hosts, and a Creality K1 Max. I cannot use Knomi V2.0 with three of these printers.
Note that Knomi V1.0 allowed the port specification, so this should be considered a regression.
Thank you for your consideration. I'm keen to make use of Knomi V2.0!
The text was updated successfully, but these errors were encountered: