You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
{{ message }}
This repository has been archived by the owner on Dec 26, 2023. It is now read-only.
It is just a suggestion about section 3 of the configuration file.
In my case I plan to use a Matrix extruder but with the stock volcano block heat cartridge and thermistor.
Not a big deal to modify what I need but I suppose I am not the only one in this configuration. So, it would be nice to have section 3 and maybe 3 bis to differentiate extruder and hotend setups.
The text was updated successfully, but these errors were encountered:
Molise se veut généraliste et simple à configurer, donc je ne veux pas multiplier les configurations "exotiques". Effectivement si tu "mixes" des composants il te faut faire les modifs à la main.
Hello,
It is just a suggestion about section 3 of the configuration file.
In my case I plan to use a Matrix extruder but with the stock volcano block heat cartridge and thermistor.
Not a big deal to modify what I need but I suppose I am not the only one in this configuration. So, it would be nice to have section 3 and maybe 3 bis to differentiate extruder and hotend setups.
The text was updated successfully, but these errors were encountered: