You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
avrdude: Device signature = 0x1e950f (probably lgt8fx328p)
avrdude: NOTE: "flash" memory has been specified, an erase cycle will be performed
To disable this feature, specify the -D option.
avrdude: erasing chip
avrdude: reading input file "grbl_v1.1h.20190825.hex"
avrdude: input file grbl_v1.1h.20190825.hex auto detected as Intel Hex
avrdude: writing flash (29920 bytes):
Mam płytę jak w załączniku.
I updated using the programmer to GRBL 1.1. I used this guide: link
`F:\download\avrdude>avrdude -p atmega328p -c usbasp -Pusb:bus-0:\.\libusb0-0001--0x1781-0x0c9f -b19200 -Uflash:w:grbl_v1.1h.20190825.hex
avrdude: AVR device initialized and ready to accept instructions
Reading | ################################################## | 100% 0.03s
avrdude: Device signature = 0x1e950f (probably lgt8fx328p)
avrdude: NOTE: "flash" memory has been specified, an erase cycle will be performed
To disable this feature, specify the -D option.
avrdude: erasing chip
avrdude: reading input file "grbl_v1.1h.20190825.hex"
avrdude: input file grbl_v1.1h.20190825.hex auto detected as Intel Hex
avrdude: writing flash (29920 bytes):
Writing | ################################################## | 100% 16.58s
avrdude: 29920 bytes of flash written
avrdude: verifying flash memory against grbl_v1.1h.20190825.hex:
avrdude: load data flash data from input file grbl_v1.1h.20190825.hex:
avrdude: input file grbl_v1.1h.20190825.hex auto detected as Intel Hex
avrdude: input file grbl_v1.1h.20190825.hex contains 29920 bytes
avrdude: reading on-chip flash data:
Reading | ################################################## | 100% 9.41s
avrdude: verifying ...
avrdude: 29920 bytes of flash verified
avrdude: safemode: Fuses OK (E:FD, H:DE, L:FF)
avrdude done. Thank you.`
After updating, Lasergrbl does not detect the CNC.
Have I done something wrong?
Can't this firmware be uploaded to this board?
The text was updated successfully, but these errors were encountered: